Bite Alarms

23A 12V Alarm Battery

For NGT Alarms. The A23 battery (also known as 8LR932[1], 8LR23, GP23A, MN21, V23GA, 23AE, L1028 or ANSI-1181A)

The brand of the battery changes with each shipment that we get.

Out of stock

Free shipping

Ambush Alarm O Rings

These O-rings fit all standard size bite alarms. Comes in a package of 10.

O-rings tend to wear out, so to get a nice secure fit between your alarm and buzzbar and/or bank stick.

ATT V2 Leather Pouch Deluxe

Quality leather pouch for the ATTx Deluxe Receiver.

Only 1 left in stock

ATTs Alarm Battery

Batteries for the ATTs Silent Alarm. 1 battery required per Alarm. Brand may vary.

ATTs Alarm Spares / Accessories Pack

The kit includes all the spare or replacement parts required to perform basic maintenance on your ATTs alarm.

Contents:
2 x spare roller wheel bolts
8 x spare back cover screws
2 x spare seals
2 x locking nuts

Please note that the kit does not include spare roller wheels, Betalites or batteries.

Each kit services 1 alarm.

Only 6 left in stock

A replacement protective hard case for the ATTs range of alarms, including original ATTs, Crystal and Underlit heads.

These cases include an integral magnet that switches the alarm off when in place.
Protects them from damage during storage or transit.
These hard cases now have an improved texture to make getting them on and off the alarm heads much easier.

ATTs Underlit Wheel Alarm

After the phenomenal success of the original ATTs silent heads, the team at ATT have released the eagerly anticipated illuminated wheel version of their trend setting system.

The Deluxe Receiver now features an in-built stub aerial that gives the receiver extra range and it now uses 2 AA batteries. This small change means that the unit has longer working life on each set of batteries and it also helps to increase the workable range of the receiver, improving the signals penetration of foliage. The casing is still the same high quality soft touch finish and is now extremely water resistant! Significant improvements to the electronics mean that receiver now has 10 independent channels (twice that of the standard receiver) and each channel can be programmed to a different tone output; selected from the 21 tones available. Volume is adjusted through 5 settings using the SSI (Silent Step Increment) system, controlled by the ‘+’ and ‘–‘ buttons on the side of the receiver, with the volume being indicated by the LED display on the front of the unit. You still have the choice of Vibrate on/ off, but this is now complimented by the vibrate mode automatically switching on when the speaker output is reduced to silent. Another really nice improvement is that the first bleep is no longer a ‘double bleep’.

Finally, the receiver is supplied 7 colour lenses (5 fitted and 2 optional colours), with all the colours available to purchase for those anglers that want to customise the colour array they are using.

Only 1 left in stock

Soft Touch, non-reflective, rubberised finish on Receiver and Transmitters.
Improved Battery Life on Receiver and Transmitter – The Receiver is powered by a single AA Battery providing a battery life of up 3 weeks of normal use.
The Transmitter is powered from a single GP11A battery lasting up to 1 season of normal use. The batteries supplied are tester batteries only.
Mimics Alarm Beeps – The Receiver beeps at the same rate at which signals are received by the Transmitters, from the buzzer output, thereby sounding anything from a single bleep to a full-blown ‘one-toner’.
Improved Range and Performance – tested to 100m + range under optimum bank side conditions.
Multiple Tone Selection on the Receiver – 10 different user selectable tones.
Improved Transmitter Design –The electronic circuitry is encased in its own watertight compartment to prevent the risk of water coming in, transmitter corrosion and any resultant malfunction.
Activation on all LEDs (for simultaneous runs).
Last LED Activation Recall.
LED’s will remain on for 40 seconds after the last buzzer signal is received from the transmitter.
Vibrate mode and Volume control.
Low Battery Warning.
Fully compatibility with the Deluxe Receiver.
Standard system comes with Multi Coloured V2 receiver that has 5 different coloured LED’s – Red, White, Blue, Green and Orange.

ATTx V2 Remote System 3.5mm (Fits Older Delkim alarms only)

These do not work with the new EV-D Alarms
Soft Touch, non-reflective, rubberised finish on Receiver and Transmitters.
Improved Battery Life on Receiver and Transmitter – The Receiver is powered by a single AA Battery providing a battery life of up 3 weeks of normal use.
The Transmitter is powered from a single GP11A battery lasting up to 1 season of normal use. The batteries supplied are tester batteries only.
Mimics Alarm Beeps – The Receiver beeps at the same rate at which signals are received by the Transmitters, from the buzzer output, thereby sounding anything from a single bleep to a full-blown ‘one-toner’.
Improved Range and Performance – tested to 100m + range under optimum bank side conditions.
Multiple Tone Selection on the Receiver – 10 different user selectable tones.
Improved Transmitter Design –The electronic circuitry is encased in its own watertight compartment to prevent the risk of water coming in, transmitter corrosion and any resultant malfunction.
Activation on all LEDs (for simultaneous runs).
Last LED Activation Recall.
LED’s will remain on for 40 seconds after the last buzzer signal is received from the transmitter.
Vibrate mode and Volume control.
Low Battery Warning.
Fully compatibility with the Deluxe Receiver.
Standard system comes with Multi Coloured V2 receiver that has 5 different coloured LED’s – Red, White, Blue, Green and Orange.

ATTx V2 Transmitter 3.5mm

Transmitters enable you to wirelessly pair most alarms to a ‘V2’ or ‘Deluxe’ ATT Receiver simply by plugging them into the alarm’s output jack plug socket.

These transmitters feature:

Soft Touch, non-reflective, rubberized finish.
Improved Transmitter Design.
All integral electronic circuitry is encased in its own watertight compartment to prevent the risk of water coming in and potentially causing corrosion.
3.5mm Jack Plugs, to suit a wide range of current alarms including Delkim EV.
These transmitters are powered by a GP11A battery (or equivalent).